Publicité
Les langues disponibles
Les langues disponibles
9. Installation
9.1 Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall
be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please
select heat-resistant and insulated work surface material (Wood and
similar fibrous or hygroscopic material shall not be used as work
surface material unless impregnated) to avoid the electrical shock and
larger deformation caused by the heat radiation from the hotplate. As
shown below:
Note: The safety distance between the sides of the hob and
the inner surfaces of the worktop should be at least 3mm.
L(mm)
W(mm)
590
520
H(mm)
D(mm)
60
56
A(mm)
B(mm)
560+4
490+4
+1
26
X(mm)
50
+1
mín
F(mm)
3
mín
V.1
Publicité
