Eurocave La Premiere Mode D'emploi page 32

Installation of an AXUH storage shelf
a.
b.
Note: to install a storage shelf the back section of which rests on the ledge, located at the back of the cabinet, fit 2 rack support pins at
the front to support the front section of the shelf (pins supplied in the accessories bag).
The same applies if you place a storage shelf just above the stiffener, position two rack support pins at the back of the cabinet (for large
models only).
Layout advice
Your EuroCave wine cabinet has been designed to safely hold a
maximum number of bottles. We recommend that you observe the
following advice to optimize loading.
• Distribute your bottles as uniformly as possible
over the various cabinet shelves, in order to spread
the weight. Also ensure that none of the bottles
is touching the rear wall of the cabinet.
• Spread the load over the entire cabinet rather than
placing bottles all at the top or all at the bottom.
• Observe the loading instructions for the specific
storage layout of your cabinet and never stack
bottles on a sliding shelf.
• If you have sliding shelves, it is preferable to position
them in the central and upper section of your
cabinet to facilitate daily access.
14
GB
5/ LAYOUT – STORAGE
c.
• In the same way, place one or two bottles of each
of your different wines on the sliding shelves and
keep spare bottles on the storage shelves. You then
simply replace bottles when they are consumed.
1
d.
1
back
2
wall
NB: Never modify the position of the stiffener in your
cabinet (see description page 6) without first consulting
your retailer and never handle this part when the
cabinet is loaded.
2