Publicité
Les langues disponibles
Les langues disponibles
3/ PROTECTING THE ENVIRONMENT / ECO-DESIGN
Spare parts for our appliances
are available for 11 years. For
further information, contact
your EuroCave stockist. For
France, contact our customer
service department. Contact
details at www.eurocave.com
Disposal of packaging
All packaging used by EuroCave is made from
recyclable materials.
After unpacking your cabinet, take the packaging
to a refuse collection point. For the most part, it
will be recycled.
• When your cabinet is delivered, check the outside for signs of damage
(impact, warping...).
• Open the door and check that the various elements inside are intact
(walls, Main du Sommelier supports, hinges, bottle support...).
• Remove the protective elements found inside and outside your cabinet
including the lower hinge protector (see diagram (1))
• Fit the cap (see diagram 2), found in the accessories bag, used for sealing
the hole in the lower hinge.
• Protective wedges for transportation have been attached to each shelf.
2 wedges per shelf (Picture 1). Remove all of them using a rotating
movement (Picture 2). You can retain these wedges and reuse them if
you have to transport your wine cabinet over a long distance.
2/ POWER SUPPLY
The wine cabinet's power lead has a plug, to be plugged into a standard earthed outlet to prevent
any risk of electric shock.
Contact your usual EuroCave retailer to change the power lead if it is damaged. It must be replaced
by a EuroCave original manufacturer's part.
Recycling: a caring gesture
Electrical and electronic equipment can have a
harmful effect on the environment and human
health owing to the presence of hazardous
substances.
You should never therefore trash electronic and
electrical equipment with unsorted municipal
waste.
When purchasing a new EuroCave product, you
can entrust recycling of your old appliance to
your EuroCave retailer.
Speak to your EuroCave retailer. He will explain
the removal and collection arrangements set up
in the EuroCave network.
In compliance with legislation relating to
protecting and caring for the environment,
4/ INSTALLING YOUR WINE CABINET
1
2
Have the power supply socket checked by a qualified electrician who will check that it
is correctly earthed and will carry out, if necessary, work to ensure that the socket
complies with current standards.
If you are moving to a foreign country, check that the supply characteristics of the
cabinet correspond to the country (voltage, frequency).
Picture 1
Precautions
• Do not place your cabinet in an area liable to flood.
• Do not place your cabinet close to a source of heat or expose it to
direct sunlight
• Prevent water from splashing on any parts of the rear of the machine.
• Arrange the power lead so that it is accessible and does not come into
contact with any of the appliance's components.
• Tilt the cabinet slightly backwards in order to adjust the front feet (by
screwing or unscrewing them) so that you can level your cabinet (spirit
level recommended).
your wine cabinet does not contain C.F.C.s or
H.C.F.Cs.
To save energy
• Install your wine cabinet in a suitable
location (see following page) and observe the
recommended temperature ranges.
• Keep the door open for as short a time as
possible.
• Ensure that the door seal is in good working
order and that it is not damaged. If it is,
contact your EuroCave retailer
• We recommend that you fill your wine
cabinet to at least 75% of its total capacity.
Disable any unusable appliances by unplugging
them and cutting off the power lead.
Picture 2
7
GB
Publicité
