Publicité
Les langues disponibles
Les langues disponibles
8
Faults
Before you contact after-sales service
FAULT
Appliance is not
working.
Dishes are not dry or
not properly dry
Plastic tableware is not
properly dry
Cutlery is not dry
Page | 24
POSSIBLE CAUSE
Fuse blown or fused circuit-
breaker tripped.
Plug is not plugged in to the
plug socket.
Low water pressure
Appliance door does not
close properly.
No rinsing agent used or
dosage set too low
The detergent used has a
poor drying performance
Selected programme has no
"Dry" function
The "Extra dry" function was
not activated.
Water collects in recesses in
the crockery or cutlery
Drying process was not yet
finished
Normal phenomenon. Poorer
drying performance for
plastic.
Cutlery incorrectly sorted
REMEDY
Check fuses.
Plug the mains plug into the
plug socket.
Check whether the water
supply hose is correctly
connected and the tap is
properly turned on.
Close the appliance door.
1. Fill with rinsing agent
2. Regulate rinsing agent
quantity
Use rinsing agent or combined
detergent with higher drying
capacity
Select programme with "Dry"
Activate the "Extra dry"
function, if available
Put away dishes at an angle if
possible
Wait until the programme
ends. Open the door a little
after the end of the
programme. Steam can
escape and the dishes dry out.
No remedy possible
Put away cutlery correctly
(see chapter 4.5"Loading
crockery/cutlery baskets")
Publicité
