Publicité
Les langues disponibles
Les langues disponibles
5.2 Information about the eco programme
The eco programme is suitable for cleaning normally soiled dishes. The eco programme is
the most efficient programme in terms of combined energy and water consumption.
The eco programme is used to check compliance with EU eco-design rules. The basis is
DIN-EN 60436. The water hardness setting should be selected for 14dH or 2.5°mmol/l.
Set the rinsing agent setting to "6" or maximum. The measurements are performed
under defined conditions (laboratory conditions). Deviations in daily operation are
possible.
The specifications in the following table for other programmes are only reference values.
The information on duration and energy and water consumption cover one operating
cycle.
5.3 Starting the washing programme
1.
Pull out the crockery baskets, fill with crockery and push in again.
2.
Load the cutlery basket and push it back in again.
3.
Pour in dishwasher detergent (see chapters on regenerating salt, rinsing
agent, dishwasher detergent in the chapter "Putting into operation").
4.
Turn on the water tap completely.
5.
Press the "ON/OFF" button and switch on the appliance.
6.
Press the "Programme" button and select a "washing programme" (see
"Programme table"). The corresponding programme lamp lights up.
7.
Close the appliance door.
8.
Press the "Start/Pause" button and the appliance starts the wash cycle.
Ø A click can be heard when the door is closed correctly.
Ø Do not close the door until the crockery baskets have been pushed
back in. This avoids unnecessary slamming of dishes.
Ø Do not drop cutlery (especially knives) into the cutlery basket. A
cautious approach increases the lifetime of the appliance.
5.4 Changing the washing programme
When the water has run in completely, or the dishwasher detergent has flowed in, a
change of programme is no longer possible without a restart. In this case, fill the
container with dishwasher detergent again. (see chapter "Filling dishwasher detergent").
Press the "Start/Pause" button to interrupt the washing process.
1.
Press and hold the programme button for 3 seconds to cancel the programme.
2.
Press the "Programme" button and select the desired programme.
3.
Press the "Start/Pause" button and the appliance starts the selected
programme after 10 seconds.
Page | 19
Publicité
