Publicité
Les langues disponibles
Les langues disponibles
Connecting the supply hose
1. Connect the water inlet hose to the ¾" threaded
connection of the tap. Ensure correct screw connection
(do not cant). Check tightness.
2. Ensure that the supply hose is not kinked or pinched.
Connect the drain hose.
1. Ensure that the drain hose is not kinked or pinched.
®
The waste water must be able to drain
unhindered.
2. Do not insert sink plugs while the appliance is pumping water out. Otherwise the
water will run back into the appliance.
(A) Connect the drain hose to a floor drain. Note the minimum connection height of
400 mm.
(B) Direct connection to the siphon of a washbasin/sink. The maximum connection
height of ≤ 1000 mm must be observed. Connection should only be carried out by
a specialist.
(C) Floor drain diameter
Hose extension
•
Only use an identical drain hose as a hose extension and have it professionally
installed. Contact After Sales Service.
•
In order not to affect the cleaning power of the dishwasher, the hose extension
must not be longer than 2 m.
3.1 Electrical connection
A prerequisite for the electrical connection is a properly installed protective contact plug
socket, with its own adequate fuse protection (220-240V
pulse-sensitive fault-current circuit breaker (RCD switch) is recommended.
RISK OF ELECTRIC SHOCK!
The appliance must be earthed according to the local regulations. For this purpose, the
plug of the connecting cable is fitted with a contact provided for this purpose.
~
/50 Hz/10A). The use of a
Page | 11
Publicité
