Publicité
Les langues disponibles
Les langues disponibles
FIRE HAZARD
Do not connect the appliance to a multiple socket, power strip or similar.
Ø If the plug does not fit into the plug socket, contact a qualified
electrician.
Ø Do not use an extension cable with an adapter plug for this appliance.
4
Putting into operation
Before putting the appliance into operation, make the following settings and fill the
appliance with regeneration salt, rinsing agent and dishwasher detergent.
4.1 Setting the water hardness
Before putting the appliance into operation for the first time, adjust it once to the local
water hardness. You can obtain this information from the water supplier or on the
Internet.
•
The water softener serves to remove minerals and salts from the water that
could damage the appliance or have an undesirable effect on the dishes.
1.
The more minerals and salts your water contains, the harder the water. Switch
on the appliance.
2.
Press and hold down the "Programme" button within 60 seconds of switching
on the appliance for slightly longer than 5 seconds.
3.
Select the appropriate water hardness with the "Programme" button
H3>H4>H5>H6>H1>H2.
4.
Press the "Programme" button and save the selected water hardness.
Carry out the settings using the following table
Factory setting: H3
WATER HARDNESS
ºdH
ºfH
0~5
0~9
6~11
10~20
12~17
21~30
18-22
31-40
23~34
41~60
35~55
61~98
1° dH = 1.25° Clark = 1.78 °fH = 0.178 mmol/l
° dH: German hardness ° Clark: British hardness ° fH: French hardness
Page | 12
ºClark
ºmmol/l
0~6
0~0.94
7~14
1.0~2.0
15~21
2.1~3.0
22-28
3.1~4.0
29~42
4.1~6.0
43~69
6.2~9.8
Display
H1= Short lights up
H2= 90 Min lights
up
H3 90 Min, Short
lights up
H4= Eco lights up
H5 Eco and Short
light up
H6 Eco and 90 Min
light up
Salt consumption
(grammes/cycle)
0
9
12
20
30
60
Publicité
