Publicité
Les langues disponibles
Les langues disponibles
Cleaning the appliance door
•
Clean the door frame with a damp cloth.
•
Never use spray cleaners or the like to prevent water from penetrating the door
lock and electrical elements.
Frost protection measures
If the appliance is located in a place where temperatures are close to or below freezing,
observe the following:
ü Remove the mains plug from the plug socket or switch off the fuse.
ü Turn off the water tap and unscrew the supply hose.
ü Allow the water to drain from the supply hose and inlet valve. (Place a vessel
under the hose to collect the water.)
ü Connect the inlet hose to the inlet valve again.
Remove the filter from the tray in the bottom of the dishwasher and draw the
water out of the rubber ring using a sponge.
7
Decommissioning the appliance
Observe the sequence of the work steps:
1. Pull out the mains plug or switch off the fuse for the plug socket.
2. Turn off the water tap.
3. Loosen the inlet and outlet hose.
4. Loosen fixing screws from the worktop, if present.
5. Remove the base board, if present.
6. Pull out the appliance, carefully pulling out the hoses at the same time.
Allow remaining water to drain from the hose
If the sink is 1000 mm or more from the floor, the remaining water cannot run out
directly into the sink.
In this case, collect the remaining water from the hose in a suitable vessel outside the
sink.
Transport
ü Empty the appliance and secure loose parts.
ü Transport the appliance only upright (so that no remaining water can run into the
machine controller and cause programme errors).
Page | 23
Publicité
