Publicité
Les langues disponibles
Les langues disponibles
5 - I
NSTALLING YOUR WINE CABINET
N.B.: The oxygen extraction heads must never be used for fizzy wines (e.g. Champagne), only for still wines.
- When your appliance is delivered, ensure, after unpacking, that your cabinet shows no exterior appearance defects (impacts,
buckling, etc.).
- Open the door and check the integrity of the inside of your appliance (walls, shelves, hinges, control strip, etc.).
- In the event of a problem, contact your EuroCave dealer.
- Now move your cabinet to its chosen location.This location should:
- be open to the exterior to enable air circulation (not a closed cupboard, etc.),
- be removed from any heat source,
- not be too damp (laundry room, utility, bathroom, etc.),
- have a solid and flat floor
- have a power supply (standard outlet, 16A, earthed with a 30mA* circuit breaker,
(not applicable for some countries)).
- Do not place your cabinet in an area that might be flooded.
-Do not place the appliance near to a source of heat or directly expose it to the sun's rays.
- Avoid water splashes over all or part of the back of the appliance.
- Take the power lead (which you will find inside your cabinet's "accessories" box) and connect it to the connector
at the bottom left of the cabinet (see adjoining diagram).
- Release the power cable so that it is accessible and position your appliance, leaving a space of 5 to 10cm
between the wall and the rear of your wine cabinet.
- If you are placing your appliance under a work top, create a space of 2 cm between the work top and the top of the cabinet.
- Release the power cable so that it does not enter into contact with any part of the appliance.
- gently tip cabinet backwards in order to adjust the front feet (by unscrewing or tightening), so as to achieve a level for your cabinet (we recommend the
use of a spirit level).
- Remove the protective elements inside your cabinet.
- This wine cabinet is designed to be used as a free standing unit only.
- Never connect several wine cabinets to a multi-socket.
6 - C
OMMISSIONING YOUR WINE CABINET
1- Connection
Check that your plug is correctly supplied with power (presence of correct fuse amps, functioning 30 mA* circuit breaker (not applicable to some countries)).
Connect one end of the power supply cable to the appliance and the other end to the power supply socket to power it up.
N N . . B B . . ! ! Observe the connection direction: arrow on the top. Do not apply force.
The use of an extension cord or multi-socket is not recommended.
7 7
E E N N
Publicité
