Bosch GNH 18V-64-2 Professional Notice Originale page 29

Problem
The power tool skips nails or has a cycle
feed that is too large.
Nails are frequently jamming in the shot
duct.
The driven nails are bent.
After-Sales Service and Application Service
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. You can find explosion drawings and information on
spare parts at: www.bosch-pt.com
The Bosch product use advice team will be happy to help you
with any questions about our products and their accessor-
ies.
In all correspondence and spare parts orders, please always
include the 10‑digit article number given on the nameplate
of the product.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham Uxbridge
UB 9 5HJ
At www.bosch-pt.co.uk you can order spare parts or arrange
the collection of a product in need of servicing or repair.
Tel. Service: (0344) 7360109
E-Mail: boschservicecentre@bosch.com
You can find further service addresses at:
www.bosch-pt.com/serviceaddresses
Bosch Power Tools
Cause
The fasteners are too long.
The depth stop is set too high.
The fasteners being used are not ap-
proved.
The spring of the magazine slider is too
weak or defective.
The fasteners being used are not ap-
proved.
The nails are old, the adhesive between
the nails has lost its retention force.
The driver blade is damaged.
The nailer is being used on a material
that is not permitted (e.g. concrete,
stone).
Transport
The recommended lithium-ion batteries are subject to legis-
lation on the transport of dangerous goods. The user can
transport the batteries by road without further require-
ments.
When shipping by third parties (e.g.: by air transport or for-
warding agency), special requirements on packaging and la-
belling must be observed. For preparation of the item being
shipped, consulting an expert for hazardous material is re-
quired.
Dispatch battery packs only when the housing is undam-
aged. Tape or mask off open contacts and pack up the bat-
tery in such a manner that it cannot move around in the
packaging. Please also observe the possibility of more de-
tailed national regulations.
Disposal
Corrective measure
– Use only original accessories. Only
the fasteners (nails, staples, etc.)
specified in the "Technical Data" table
may be used.
– Adjust the depth stop to the required
depth (see "Adjusting the depth stop
(see figure D)", page 26).
– Use only original accessories. Only
the fasteners (nails, staples, etc.)
specified in the "Technical Data" table
may be used.
– Contact an authorised Bosch after-
sales service centre. Have the com-
ponent replaced there.
– Use only original accessories. Only
the fasteners (nails, staples, etc.)
specified in the "Technical Data" table
may be used.
– Contact an authorised Bosch after-
sales service centre.
– Use a new nail strip
– Contact an authorised Bosch after-
sales service centre. Have the com-
ponent replaced there.
– Only use the nailer on permitted ma-
terials (see "Intended Use", page 21).
Power tools, rechargeable batteries, accessor-
ies and packaging should be sorted for environ-
mental-friendly recycling.
Do not dispose of power tools and batteries/re-
chargeable batteries into household waste!
1 609 92A 8U5 | (22.11.2023)
English | 29