Publicité
Les langues disponibles
Les langues disponibles
Shelf in sliding version configuration:
To place bottles on a sliding shelf, carry out the following:
- Install the shelf in the selected location.
- Place a wooden locking pin in each of the two holes located on the right and
left of the upper face approximately 4cm to the rear of the shelf: when the
shelf is slid forwards, these pins stop it from sliding completely out of the
cabinet (See diagram).
- Start by placing the bottles in the rear recesses with the base of the bottles
towards the back.
- Continue by placing the bottles in the front recesses facing them in the opposite
direction.
- A sliding shelf can only hold one layer of bottles (maximum of 13
"Tradition" Bordeaux bottles).
- In order to enjoy optimum accessibility when setting up the cabinet in a
mixed layout, we recommend that shelves destined to be used as sliding
shelves are located in the middle section of the cabinet.
NEVER SLIDE A SHELf THAT HAS SEVERAL BOTTLES PILED ON
IT, OR WHEN IT HAS VERTICALLy PRESENTED BOTTLES ON IT.
You should remember that if you do not have enough bottles to fill your wine
ecommandation
cabinet, it is better to distribute the load over all of the shelves available, so as
to avoid "all on top" or "all below" type loads.
Modify the position of the locking pins when converting a sliding shelf to a
storage or presentation configuration.
The shelves all have a label slot, designed to receive the pre-cut cards
stuce
delivered with your cabinet, thus helping you to identify the position of your
favourite wines at a glance.
GB
English - P 9
Publicité
