Télécharger Imprimer la page

ArteVino Performance Serie Mode D'emploi page 26

Caves 1 température et 2 températures
Masquer les pouces Voir aussi pour Performance Serie:

Publicité

Les langues disponibles

Les langues disponibles

important
ecommandation
i
important
important
Installing your wine cabinet
When unpacking your cabinet, make sure that there are no traces of impact or
deformation and that there are no surface defects.
Carefully remove all of the protections and adhesive strips from the packaging
around your wine cabinet.
Install the handle by referring to the instructions given on the following page.
Open the door and make sure all components are intact.
Release the electrical lead.
Move your cabinet to its final location.
This appliance is not intended to be used by persons (including children)
with reduced mental, sensory or physical abilities, or by persons with no
knowledge or experience, except where they are supervised or given prior ins-
tructions regarding the use of the appliance by somebody responsible for their
safety. Children should be supervised to ensure that they do not play with the
appliance.
As a security measure, the lock works on a double movement system. The key
should be pushed inward and turned at the same time.
The place you have selected for your cabinet should:
- Be unencumbered and well ventilated,
- Enable a minimum 10 cm space between the wall and the back of the cabinet,
- Be well away from any heat source,
- Not be too damp (laundry, pantry, bathroom, etc.),
- Have a solid and flat floor,
- Have a standard and accessible electricity supply (standard socket to country
standards, linked to ground with differential trip),
- It is NOT recommended to use a multi-socket or extension lead..
In order for you to level off your cabinet as easily as possible, it is equipped
with 4 adjustable feet. However, we do recommend that you tighten the
back feet to the maximum and use the front feet to create a level (a spirit level
is recommended for this operation).
WAIT 48 HOURS BEfORE PLUGGING IN THE CABINET
Should you need to move your cabinet, never tilt it more than 45° and always
sideways, on the side that the electrical cable comes out (right hand side when
looking at the cabinet).
GB
English - P 7

Publicité

loading