Maxi-Cosi TR389 Mode D'emploi page 7

7
Bumper Bar
Insert posts on bumper bar into holes on frame
until you hear it "click" (Figure 7).
Pull to confirm it is assembled securely.
IMPORTANT: Always secure the child with the
restraining straps.
To remove bumper bar: Press one or both release
buttons while lifting off (Figures 7a and 7b).
NOTE: DO
NOT use the bumper bar to lift or carry.
8
Canopy
Press clips onto each side of the seat (Figure
8). Ensure that the clips are flush against the
stroller frame (Figure 8a).
Push the seat fold button through the
opening at the rear of canopy (Figure 8b).
Attach metal snaps on the canopy to snaps
on the frame (Figure 8c).
NOTE: You can extend the canopy by
flipping out the visor.
9
Cup Holder
Cup holder must be installed on right side (right from the standpoint
of one pushing stroller). Slide cup holder down onto knob (Figure 9).
CAUTION:
• Never hang parcels or accessories from cup holder as the stroller
may tip over.
• Never place more than 1-LB (0.5-kg) in cup holder.
Assembly and Use
5
7
Clips 2x
8
Shown in seat mode.
7a
Flush
8a 8b
9
7b
8c