Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Cleaning the grid and filters
1. Remove the grid from the extraction inlet.
2. Carefully pull the grease filter out of the extraction inlet.
•
Clean the grid with hot water and neutral soap, without using abrasive sponges (do not use
detergents!). Do not wash the cast iron grid in a dishwasher.
•
Clean the grease filter, when in use, at least every week (or when the filter saturation
indication system indicates this necessity. This will maintain good performance of the
extractor and prevent a potential fire hazard, caused by excessive grease build-up.
•
Clean the filter with a non-aggressive detergents, preferably by hand or els in the
dishwasher, which must be set to a low temperature and a short cycle.
Odour filter (recirculation use)
Replace the odour filter at least once a year depending on the intensity of use of operation (or
when the filter saturation indication system indicates this necessity). Carefully remove the filter; it
is positioned with magnets on the sides.
When inserting the new filter, pay attention to the arrow that indicates the direction of the airflow.
Put the filter back and reset the memory of the filter saturation indication on the appliance.
EN 31
Publicité
