HQ Power VDPLSC3 Mode D'emploi page 5

3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
Protect this device from shocks and abuse. Avoid brute force when operating the
device.

Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Mechanical wear and LEDs are not covered by warranty.

A qualified technician should install and service this device.

Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.

This device is designed for professional use on stage, in discos, theatres, etc.

Use the appropriate power supply (see Technical Specifications below).

Lighting effects are not designed for permanent operation: regular operation breaks will prolong their
lives.

There may be some smoke or a particular smell when the device is activated for the first time. This is
normal and any smoke or smell will gradually disappear.

Use the original packaging if the device is to be transported.

Keep this manual for future reference.
4. Features
With its dimensions of 2 x 3 m and its 176 tri-colour RGB SMD LEDs, the LED STARCLOTH II is the
perfect solution for all kinds of smaller on-stage shows. It comes with a high-quality carrying bag for
easy transportation.
The LED STARCLOTH II features 30 pre-programmed auto programmes with colour fades to more
graphical effects. All of them are user-friendly in stand-alone or DMX mode.

delivered with controller and carrying bag

DMX control:
8 channels: dimmer, strobe, R, G, B, programme 1, programme 2, speed
o

master/slave, stand-alone and sound-controlled mode

lightweight so easy to hang on all kinds of structures
5. Overview
Refer to the illustrations on page 2 of this manual.
1
LED display
2 power input
3 on-off switch
4 ground point
5 DMX input
6 DMX output
V. 01 – 15/07/2015
Keep this device away from dust and extreme temperatures. Make sure the
ventilation openings are clear at all times. For sufficient air circulation, leave at
least 6" (± 15 cm) in front of the openings.
VDPLSC3
7
signal output
8 LED curtain
9 LED
10 HOLD button
11 signal cable
5 ©Velleman nv