Efco DS 2600 4S Manuel D'utilisation Et D'entretien page 14

en
21
23
14
ASSEMBLY
WARNING: Only use cutting attachments with the
guards we recommend! See the chapter on
Recommended cutting attachments (Page 10). Refer
to the instructions for the cutting attachment to
check the correct way to load the cord and the
correct cord diameter. Keep the teeth of the blade
correctly sharpened! Follow our recommendations.
Also refer to the instructions on the blade packaging.
Maintain the correct blade setting! Follow our
instructions.
WARNING: Always stop the engine before doing any
work on the cutting attachment. The attachment
continues to rotate even after the throttle has been
released. Ensure that the cutting attachment has
stopped completely and disconnect the HT lead from
the spark plug before you start to work on it.
WARNING: Using an incorrect cutting attachment or
an incorrectly sharpened blade increases the risk of
kickout.
22
WARNING: Always discard a blade that is bent,
twisted, cracked, broken or damaged in any other
way (Fig.19, page 13). Never attempt to straighten a
twisted blade so that it can be reused. Only use
original blades of the specified type.
WARNING: To reduce the risk of serious injury, never
use wire or metal-reinforced line or other material in
place of the nylon cutting lines. Pieces of wire could
break off and be thrown at high speed toward the
operator or bystanders.
Fitting the trimmer head (Fig.20, page 13- Fig. 21)
Put the upper (A) flange in place. Push the head fixing button (B)
and tighten the head (C) counter-clockwise by hand.
Fitting the blade (Fig.22-23)
Loosen the nut (A) for DS 2600 4S or screw (A) for DS 3600 4S
clockwise; remove cup (B) and lower flange (C). fix the blade (D)
onto the upper flange (F) making sure that the rotation direction is
correct. Fix the lower flange (C), the cup (B) and tighten nut (A) for
DS 2600 4S or screw (A) for DS 3600 4S counter-clockwise. Push
24
the button (F) to block the blade and allow the nut (A) to be tigh-
tened to 18.4 ftlb (25 Nm).
WARNING: Arrows on the cutting attachment guard
(Fig.24) show the correct direction of rotation of the
cutting tool.
WARNING: Fit the blade protection (M) p.n. 4196086
as shown (Fig.25) before transporting or storing the
brush cutter.
CAUTION: Never use the brush cutter without the cup
(B, Fig.22-23) to avoid damages to the thread.
25