Engine; Spark Plug; Spark Arresting Muffler - Efco DS 2600 4S Manuel D'utilisation Et D'entretien

MAINTENANCE

Engine

Clean the cylinder fins with compressed air or a brush
periodically (Fig. 68). Dangerous overheating of engine may occur
due to impurities on the cylinder.
WARNING: Never run the machine without all the
parts, including the starting housing, securely in
place.
Because parts can fracture and pose a danger of
thrown objects, leave repairs to the flywheel and
68 clutch to trained Servicing Dealers.

Spark Plug

This engine uses a NGK CMR5H with 0.024-0.028 in (0.6-0.7 mm)
electrode gap (Fig. 69). Use an exact replacement and replace
every six months or more frequently, if necessary.
WARNING: Never test the ignition system with
ignition wire connector removed from spark plug or
with unseated spark plug, since uncontained
sparking may cause a fire. A loose connection
between spark plug terminal and ignition wire
69 connector in the boot may create arcing that could
ignite combustible fumes and cause a fire.
Use only resistor type spark plugs of the approved range.
Factors such as:
- dirty air filter;
- unfavourable running conditions, e.g. operating at part load;
may result in rapid deterioration of the spark plug.

Spark Arresting Muffler

70
The brush cutter is provided with a Spark Arrester System p.n. S-
419 (DS 2600 4S) - S-421 (DS 3600 4S) (Fig. 70) complying with
the requirements of SAE J335 standard; you can check the p.n. of
the Spark Arrester System on the muffler itself.
WARNING: A faulty or altered spark arrester system
screen can create a fire hazard.
Through normal use the screen can become dirty and should be
inspected weekly and cleaned as required.
To clean:
• Allow the muffler to cool.
• Remove the two (2) deflector screws (A).
• Remove the deflector and spark arrester (B, Fig. 71).
71
• Clean and inspect the spark arrester screen. If the spark
arrester screen is damaged, faulty or deteriorated, replace the
screen.
• Reassemble components in reversed order of removal and
torque the screw to 45 in/lbs (4.9 Nm).
WARNING: If the spark arrester screen is damaged,
faulty or deteriorated, replace the screen or entire
muffler assembly.
en
29