Electrical Connection - Glatz PALAZZO STYLE Notice De Montage Et D'utilisation

EN

2.1 Electrical connection

2.1.1 Main line
The supply line has to be provided on site. It has to be possible to
disconnect it for installation and maintenance purposes and to protect it
against unintentional reactivation.
Connection values for systems without heater:
- 230 V~ P + N + PE, 50 Hz, 10 A, max. 300 W
Connection values for systems with heater:
- 400 V~ 3P + N + PE, 50 Hz, 16 A, max. 4 × 1500 Watt
- 230 V~ P + N + PE, 50 Hz, 16 A, max. 2 × 1500 Watt
- 230V~ P+N+PE, 50Hz, 16A, max. 2×1500 Watt / 20A, max. 4×1000 Watt
Connect the supply line to the sunshade using the provided connector. The
connector can be stored in the support tube or in the ground socket.
2.1.2 Connection of the spiral cable (coiled cable)
The connection processes for the 2 × 0.75 mm² LED spiral cable and the
5 × 2.5 mm² heater spiral cable are identical and will be explained using
the example of the latter.
a) Mark the position of the lower cable end at the erected, open sunshade
by marking it at the lower edge of the slide disc. b) Cut the spiral cable
approximately 20 cm below the marking. c) Strip the spiral cable on the
entire length from the marking to its end.
a)
marking
b)
5 × 2.5 spiral cable:
²
d) Shorten the brown phase 1 and the white messenger cable at the
marking. e) Insert the cable in the M20 × 1.5 cable connection and fasten
it with the connection in such a way that the marking is visible at the
lower edge of the slide disc.
2 × 0.75 spiral cable:
²
f) Insert the cable in the M16 × 1.5 cable connection and fasten it with
the connection in such a way that the marking is visible at the lower
edge of the slide disc.
c)