MIRKA DEOS 383 Instructions D'utilisation page 50

en
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!
Replacing the backing pad
The backing pad is fixed with 8 screws
A = 8 mm (only on 70 × 198 mm)
B = 16 mm
Remove
1 Turn the tool upside down
2 Remove the 4 screws (A)
3 Remove the 4 screws (B)
4 Remove the backing pad
Install
1 Fit the new pad
2 Fit the 4 screws (B)
3 Fit the 4 screws (A)
4 Finally tighten all 8 screws
Pad saver
Mirka's pad savers are designed to protect the backing pad from wear and tear,
when sanding aggressively and continuously with net products These cost-effective pad savers,
placed between the backing pad and the sanding strip, should be changed regularly The pad savers prolong the life
of the backing pad
https://www mirka com/accessories/pad-savers/
Further service
Servicing must always be performed by trained personnel To keep the tool warranty valid and ensure optimal tool
safety and function, servicing must be carried out by a Mirka authorized service center To locate your local Mirka
authorized service center, contact Mirka Customer service or your Mirka dealer
50
Mirka® DEOS 353, 383 & Delta 663 • 230 V
A
B
A
B
B
A
B
A