UNITED OFFICE UAV 300 A1 Mode D'emploi Et Consignes De Sécurité page 11

Inserting credit cards
Fig. 4
NOTE
► Always insert the credit card into the middle of the CD/credit card cutter
opening
► If you want to ensure that the information on the magnetic strip is irrevocably
destroyed, insert the credit card into the middle of the cutter opening for
paper
position.
Note that the residue will then fall into the large waste collector
If necessary, empty this beforehand in order to keep paper and plastic
waste separate.
Inserting a CD
WARNING! RISK OF INJURY!
► Never insert your finger into the central hole of a CD when you are feeding
it into the appliance.
Fig. 5
Clearing a material blockage
♦ Move the REV/OFF/AUTO/FWD switch
if the material being shredded causes a jam. The appliance now goes into
reverse and the material is ejected.
Alternatively, move the REV/OFF/AUTO/FWD switch
♦
("forward") position if the material causes a blockage. The appliance is now
in forwards operation and the material that is being shredded is pulled in
again.
Move the REV/OFF/AUTO/FWD switch
♦
the jammed material has been ejected.
GB │ IE
│
■ 8
Insert the credit card from above into the middle of the
CD/credit card cutter opening
the REV/OFF/AUTO/FWD switch
("forward") position.
You can only shred one credit card at a time. Always insert
the card into the CD/credit card cutter opening
the wide side first. Otherwise, the magnetic strip will not
be destroyed.
2
. Otherwise, the shredding process will not start.
9
and move the REV/OFF/AUTO/FWD switch
Move the REV/OFF/AUTO/FWD switch
position for shredding. Insert the CD from above into the
middle of the CD/credit card cutter opening
You can only shred one CD at a time.
2
(see fig. 4) and move
3
to the FWD
3
to the FWD
3
to the AUTO
2
3
to the REV ("reverse") position
3
to the FWD
3
to the OFF position as soon as
UAV 300 A1
2
with
w
.
(see fig. 5).