HEBU medical HBS x-touch 200i Mode D'emploi page 33

HBS x-touch 200i
2 Introduction
Our products are exclusively intended for professional use by appropriately trained and qualified
personnel and may only be acquired by them.
An electrosurgical unit is a generator used to transform electronic energy into high-frequency
alternating current (HF current). If this current flows through human tissue, it creates heat which is
used for cutting and for coagulation of the tissue.
The HBS x-touch 200i is a versatile and compact electrosurgical unit which complies to a high safety
standard and unites economy with operative flexibility.
It offers the following application modes:
For monopolar surgical use
•
Pure cut
•
Blend cut
•
Polypectomy mode
•
Monopolar cutting in moist environment (TUR)
•
Soft/Contact coagulation (no sparks/desiccate mode)
•
Forced coagulation
•
Spray coagulation
•
Monopolar coagulation in moist environment (TUR)
For bipolar use:
•
Bipolar cut (Bipolar Scissors)
•
Bipolar cutting in moist environment (TUR)
•
Bipolar coagulation (mode "Bipolar Forceps")
•
Bipolar cutting in moist environment (TUR)
•
Bipolar coagulation (mode "Bipolar Forceps AUTO Start")
•
BiSeal coagulation
Benefits of the HBS x-touch 200i:
◼
Simple, intuitive and safe operation
◼
Current terminal for optional wireless foot switch, max. 0.5 A
◼
Display-supported neutral electrode safety system helps interactively when applying the neutral
electrode
◼
Nine storage locations for individual program settings
◼
One monopolar multifunction terminal for 3-pin standard or Martin plug
◼
AutoStop function for automatic interruption of the energy supply after a certain tissue resistance
level is reached.
◼
Tone signal with scope for control of the volume and an alarm tone in case of faults without facility
for switching off
◼
Coloured illumination of the LCD display in red, yellow, blue to indicate different operating modes
or error statuses
◼
Facility for tracing output and impedance at the LCD display in the patient circuit on activation
◼
HEBU generators have an automatic output dosage by impedance with voltage regulation and
arcing regulation and an automatic power adjustment with dynamic control and stop in case of
anomalies.
◼
Worldwide application possible through connection scope from 100 to 260 volts, 50 to 60 Hz
EN
33