GiBiDi BE24G Instructions Pour L'installation page 33

33
UK
17 - TROUBLESHOOTING
The gate does not move after a START
command.
The gate moves slowly.
Transmitter range is short.
The gate does not fully open/close.
The gate moves slowly during opening.
Ÿ Check that L3, L4 and L5 are off; if not, check the devices connected to
terminals 19-20-21.
Ÿ
Check fuses.
Ÿ
Check that the battery voltage is not below 22VDC.
Ÿ
If L8 is blinking fast, learning procedure must be executed.
Check the control board is not running on battery.
Check terminals 26-27 screws are tight.
Check and replace transmitter battery.
Check the motor and encoder connections.
The first maneuvre after a power failer is slowed and with automatic logic.
BE24G