GiBiDi BE24G Instructions Pour L'installation page 26

BE24G
26
M5
27
28
M6
29
7 - PROTECTION FUSES
Position Value
F1 15A
15A
F2
F3 3,15A
F4 2A
8 - WARNING LEDs
Position Colour
L1 GREEN
L2 GREEN
L3 RED
L4 RED
L5 RED
L6 RED
L7 RED
L8 BLUE
GREEN
L9
Antenna braid input.
COM
Antenna signal input.
ANT
+BAT +Battery 24V MAX 3Ah.
-BAT -Battery 24V MAX 3Ah.
Type
Protects the circuit board.
F
Protects battery power circuit.
F
Protects external accessories, electric lock and flashing light.
F
Protects the transformer.
T
Signal
Comes on when the START control is activated from the terminal board or the receiver.
START
Comes on when the PED control is activated from the terminal board or the receiver.
PED
Always on. Comes off when the contact of terminal PHOTO 1 is opened.
PHOTO1
Always on. Comes off when the contact of terminal PHOTO 2 is opened.
PHOTO2
Always on. Comes off when the resistance value of terminal SAFETY is wrong.
SAFETY
Lights when the contact switch from open to close and remain on until the contact
IN1
switch off
Always off, comes on when P2 button is pressed.
RX
0,2s ON 0,2 OFF
30s ON
0,2s ON-4s OFF
INFO
1s OFF - 0,6s ON - 1s OFF
X2
1s OFF - 0,6s ON - 0,6s OFF
0,6s ON - 1s OFF
X2
Always on. It shows logic circuit power supply
VCC
Description
Description
The control board is locked, it's necessary to execute a new travel
learning procedure.
The control board is in pre-learning phase, after pressing MEMO
button.
During sleep time, the control board is set to work with GROUND
operator.
Motor 1 encoder error, travel learning procedure failed.
Motor 2 encoder error, travel learning procedure failed.
26
UK