Charging The Battery Out Of The Machine - Nilfisk Advance SC250 Instructions D'utilisation

BATTERY CHARGING
CAUTION!
Charge the battery when only one LED of the battery symbol is lit (5).
When the battery is discharged, charge is as soon as possible, as that condition makes its life shorter. Check for
battery charge at least once a week.
1. Drive the machine to the appointed recharging area.
2. Ensure that the machine is off.
3. Plug the battery charger cable plug (29) into the machine socket and the power supply cable plug into a mains socket (the
mains voltage and frequency must be compatible with the battery charger values shown on the data plate).
NOTE
When the battery charger is connected to the electrical mains, all machine functions are automatically cut off.
During charging, one of the 6 LEDs of the battery icon (5) will remain steadily on to indicate the percentage of charging
performed, while the other LEDs (to the left of the LED which is on steadily) will flash sequentially.
4. When the 6th LED of the battery icon (5) is lit steadily, battery charging is complete.
5. Disconnect the battery charger from the mains and from the machine socket (29).
6. Open the battery compartment cover (26) and place the battery charger in its tray (28).
7. Close the battery compartment (26).
CHARGING THE BATTERY OUT OF THE
MACHINE
1. Remove the battery (27) from the machine as shown in the
Removing the Battery paragraph.
2. Place the battery in the appointed recharging area.
3. Plug the battery charger cable plug (B) into the battery
socket (A, Fig. 8) and the power supply cable plug into a
mains socket (the mains voltage and frequency must be
compatible with the battery charger values shown on the
data plate).
4. During charging, one of the 6 green LEDs (C) will remain
steadily on to indicate the percentage of charging
performed, while the other LEDs (to the left of the LED
which is on steadily) will flash sequentially.
5. When the 6th LED (C) is lit steadily, battery charging is
complete.
6. Disconnect the battery charger from the mains and from
the battery.
NOTE
When the battery is not connected to the battery
charger, you can see the battery charge level by
pressing the button (D) briefly. The number of green
LEDs (C) turned on is proportional to the battery
charger level percentage.
07/2016
INSTRUCTIONS FOR USE
D
Figure 8
9100001616 - SC250
ENGLISH
A
B
C
P100939
13