Publicité
Les langues disponibles
Les langues disponibles
Programme
P6
5)
Rinse and Hold
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the
quantity of dishes can change the values.
2) With this programme you have the most efficient use of water and energy consumption for crockery and
cutlery with normal soil. (Also, it is a standard programme for test institutes).
3) The appliance senses the degree of soil and the quantity of items in the baskets to adjust the tempera-
ture and the quantity of the water and to control the energy consumption and the programme duration.
4) With this programme you can wash a load with fresh soil. It gives good washing results in a short period
of time.
5) Use this programme to quickly rinse the dishes and to prevent the food remains from drying out on the
dishes and to reduce bad odour coming out from the appliance. Do not use detergent with this pro-
gramme.
SETTINGS
PROGRAMME SELECTION MODE
In the programme selection mode it is possible to
set a washing programme and to enter the user
mode to change the appliance settings.
To enter the programme selection mode, press on/
off.
The appliance is in programme selection mode
when, after activation, the display shows the
number of the programme Eco. The programme
duration appears on the display a couple of
seconds after.
If the control panel does not indicate that the
appliance is in programme selection mode,
implement the CANCEL procedure.
CANCEL FUNCTION
Use CANCEL to:
•
CANCEL the currently running programme.
•
Stop the countdown of the Delay option.
THE WATER HARDNESS TABLE
German degrees
(°dH)
47 -50
22
Degree of soil
Programme phases
Type of load
All
French degrees
(°fH)
84 - 90
•
Pre-wash
•
Bring the appliance back to the programme
selection mode.
To CANCEL, press and hold
appliance is in programme selection mode.
USER MODE
User mode allows to change the following settings:
•
Adjust the level of the water softener according
to the water hardness.
•
Activate or deactivate the rinse aid empty
notification.
•
Activate or deactivate AirDry.
Before entering user mode, make sure the
appliance is in programme selection mode:
1. Press and hold
•
The indicators
As the appliance stores the saved settings, there is
no need to configure it before every cycle.
mmol/l
8.4 - 9.0
Consumption values
1)
Duration
Energy
(min)
(kWh)
14
0.1
and
.
,
and
Clarke degrees
58 - 63
Water
(l)
4
and
until the
flash.
Water softener
level
10
Publicité
