Télécharger Imprimer la page

R&G LP0229BK Instructions De Montage page 12

Publicité

Page | 12
TESTER LE FONCTIONNEMENT DE L'ENSEMBLE DES FEUX.
VEILLER À CE QUE LE SUPPORT DE PLAQUE SOIT CORRECTEMENT FIXÉ ET
QUE LES COMPOSANT INSTALLÉS CONCORDENT AVEC LE SCHÉMA SITUÉ
EN PAGE 1.
REGROUPER LES FILS ENSEMBLE A L'AIDE DES COLLIERS DE SERRAGE
FOURNIS (ARTICLE 10).
REMONTER LE SUPPORT PLASTIQUE COMME À L'ORIGINE.
REMONTER LE SUPPORT DE VERROUILLAGE DE SIÈGE COMME À
L'ORIGINE.
REMONTER LE SIÈGE PASSAGER COMME A L'ORIGINE.
REMONTER LA PLAQUE D'IMMATRICULATION (PEUT NÉCESSITER UN
PERÇAGE).
IMPORTANT : SI VOUS INSTALLEZ UNE GROSSE PLAQUE, IL Y A UN
RISQUE QUE LA PLAQUE ENTRE EN CONTACT AVEC LA ROUE ARRIÈRE
EN CAS DE CHOC SUR LA ROUTE (bosse, grosse charge etc....). IL EST DE
VOTRE RESPONSABILITÉ DE VÉRIFIER QUE CELA NE PUISSE PAS SE
PRODUIRE. NE PAS EFFECTUER CES VÉRIFICATIONS PEUT ENTRAÎNER
DES DOMMAGES AINSI QUE DES BLESSURES GRAVES POUR LE PILOTE.
SELON LES LOIS LOCALES, ATTACHER LE REFECTEUR ROUGE (ARTICLE 13)
A L'ENDROIT APPROPRIÉ.
TESTER LE FEU DE PLAQUE, LES CLIGNOTANTS, AINSI QUE
L'ENSEMBLE DES FEUX AVANT DE PRENDRE LA ROUTE.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable
skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products
R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have
been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good
engineering practice or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting
its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability
shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they
were purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be
in re-sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the
gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No
returns of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not
refer to faulty goods.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
POUR LE CLIGNOTANT DROIT:
3.
CONNECTEUR MARRON--------------- CLIGNOTANT JAUNE
4.
CONNECTEUR NOIR ---------------- CLIGNOTANT NOIR
RECONNECTER TOUS LES CONNECTEURS DE CLIGNOTANT AU
FAISCEAU PRINCIPAL COMME À L'ORIGINE. SI L'ÉCLAIRAGE ÉCHOUE,
TOURNEZ LES CONNECTEURS.
ISSUE 1 29/06/2017 (HH)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G Racing
www.rg-racing.com
Email:
LP0229
info@rg-racing.com

Publicité

loading

Ce manuel est également adapté pour:

Lp0229