Removing Packaging - IKRA Mogatec ITHK 800 Manuel D'utilisation

cutting blades standing still. Always put on the
protection cover when transporting or storing the
hedge trimmer. Careful handling reduces the risk of
injury through the cutting blades.
-
Keep the cable away from the cutting area. When
working with the trimmer the cable might be hidden in
bushes and accidentally cut through.
• Check the hedge for hidden objects such as wire fenc-
ing before beginning to cut.
• The hedge trimmer may not be used by persons who
are younger than 16 years of age or by persons who
have not been trained to use it.
• Keep the hedge trimmer away from children, other
persons and pets.
• Wear suitable clothing. Do not wear loose clothing or
jewellery. This could become caught in moving parts.
Wearing rubber gloves and sturdy footwear is recom-
mended. Wear a hair net if you have long hair.
• Wear a dust mask if it is dusty where you are working.
• Do not use the hedge trimmer if the cutter is not prop-
erly secured or if it is damaged.
• Make sure before switching on the hedge trimmer
that the blades do not come into contact with stones
or rubble.
• When working, keep the cutter away from your body
and extremities.
• Do not cut hard objects. This can cause injuries and
damage the hedge trimmer.
• Use only in daylight or if there is sufficient artificial
lighting.
• Never carry the hedge trimmer by the cable or pull on
the cable to pull the plug out of the socket. Keep the
cable away from heat, oil and sharp edges.
• When the hedge trimmer is not being used, store it
in a dry location in such a way that the blade is not
exposed and the hedge trimmer is out of the reach
of children.
• The mains voltage must match the voltage specified
on the type plate.
• Never use the hedge trimmer in the rain. Keep away
from the wet and the damp. Do not leave outdoors
overnight. Do not cut damp or wet grass.
• Regularly check the mains cable. Make sure before
every use that the cable is not damaged or worn. The
hedge trimmer may not be used if the cable is not in
good condition. Have the cable repaired by a special-
ist workshop.
• Only use extension cables which are suitable for
the outdoors. Keep the cable out of the cutting zone
and away from damp, wet or oily surfaces and sharp
edges. Keep the cable away from heat and fuels.
• Make sure the hedge trimmer does not start acciden-
tally. Do not carry the hedge trimmer with fingers on
both switches if the hedge trimmer is plugged in. Make
sure the switch is set to off before plugging the plug
into the socket.
• Do not attempt to remove cut materials or attempt to
hold on to materials being cut while the blades are in
motion. Make sure that the hedge trimmer has been
switched off and has come to a complete stop before
attempting to remove jammed material. Do not lift or
hold the hedge trimmer by the blades.
GB | Operating Instructions
• Do not overload the hedge trimmer. The trimmer works
• Be careful, pay attention to what you are doing. Use
• Take care of the hedge trimmer, keep the blades sharp
• A circuit breaker with a fault current of 30 mA or less is
• A tingling feeling or numbness in the hands is sign of
• A certain degree of noise from this device is unavoid-
• Put on gloves suitable for removing the foreign object.
• Then carry out a test run before continuing to work.

REMOVING PACKAGING

1. Remove the items from the box carefully. Check
2. Check the device carefully for transportation damage.
3. Do not throw any packaging materials away until
INSTALLING THE REAR HANDLE (Fig. 1)
1. Insert the handle into the telescopic pipe until it reach-
GB-8
CAUTION: The blades continue to run after the
trimmer has been switched off.
better and poses less risk of injury if it is operated as
intended.
common sense. Do not use the hedge trimmer if you
are tired.
and clean; the blades then provide the best perfor-
mance and pose less risk of injury. Check the exten-
sion cable regularly and replace it if it is damaged.
Keep the grips dry, clean and free of oil and grease.
necessary when working outdoors.
excessive vibration. Limit the operating time, take suf-
ficiently long work breaks, distribute the work between
several people or wear anti-vibration gloves when us-
ing the tool for extended periods.
able. Perform noise-intensive work at times when
this is permitted and at times intended for this type of
work. Where applicable, observe quiet times and limit
working time to the absolute minimum. You and other
persons in the area where the trimmer is being used
should wear suitable hearing protection.If a foreign
object becomes caught in the cutting tool or similar,
stop the drive immediately and wait until the cutting
tool comes to a stop.
After you remove the foreign object, you must deter-
mine whether there is any damage to the cutting tool
and the machine/safety equipment, stop work and
replace these defective parts with the spare parts
specified by the manufacturer.
whether the listed items are completely present in
the box.
you have checked the contents of the packaging for
transportation damage and commissioned the device
successfully. Do not use a damaged device until the
affected parts have been replaced and the fault has
been eliminated. Not adhering to this instruction may
result in severe injuries.
WARNING:
Always ensure that the front handle is attached to
the pole whenever you are operating this tool.
es the stop (use the guidance groove) and tighten
using the coupling ring.