Futech Multicross 8 Green Mode D'emploi page 33

Horizontal alignment
Place the device on a stable, horizontal base. It
is recommended to install the device on working
heigt. This improves the comfort while working
and will result in a higher quality.
∙ Usage of a cross line laser with a spindle or tel-
escopic tripod is optimal. The choice of the ap-
propriate tripod immediately impacts the user
friendliness of the device.
∙ The tripod adapter (8) avoids that the legs of the
device hinder when mounted on a tripod.
∙ Your device can be used on a tripod with 5/8"
screw. In case you use a tripod with a different
size of screw, provide the appropriate adapter.
Switch on the device with the on/off button (9).
(In case the central LED blinks red, you have to
changer or charge the battery first.)
After switching on the device with the on/off but-
ton (9), the device will automatically align (you
can hear the sound of the levelling motors). The
device is completely aligned once the central
LED light stops blinking and shows green per-
manently.
Push the "H" button (11) to switch on a horizontal
MULTICROSS 8 MULTICROSS 8
line. After the alignment of the device, the device
will project a perfect-levelled horizontal line.
In case the device is not positioned horizontal (=
more than 3° inclined), the device cannot align.
You will hear a beep-signal and the laser-lines will
blink. You have to put the device in a more hori-
zontal position.
∙ In case the device is put on a base, screw the
legs of the device in or out.
∙ In case the device is mounted on a tripod, short-
en or lengthen the legs of the tripod until the
device is positioned horizontal.
In case the ground under the device is not stable
enough, the levelling motors will keep trying to
align the device. The sound of the levelling mo-
tors doesn't stop. In that case, you have to move
the device (and eventually the tripod) to a more
stable ground.
By pushing the button "H" (11) again, you can
switch on more horizontal lines.
Once the 4 horizontal lines are switched on, you
can switch them off by pushing the button "H"
(11) once more.
GREEN GREEN
HIGH PRECISION HIGH PRECISION
SUPER BRIGHT SUPER BRIGHT