Publicité
Les langues disponibles
Les langues disponibles
• Check that the blade guard can freely
move and fully closes.
• Never lock-up the guard in the open
position.
• Never put sideward pressure on the
blade. This may cause the blade to
break.
• Be careful when cutting wood with
knots, nails or cracks in it and/or dirt on
it, as these can cause the blade to get
stuck.
• Never leave the circular saw
unattended.
• Use this circular saw to saw only wood
or wood-like products.
5. Using the machine
• Use clamps or a vice to hold the work.
• Never remove wood chips and saw dust
that is close to the saw blade with your
hands. If there are small pieces of wood
left between the fixed and the movable
parts, the circular saw will have to be
stopped. The plug needs to be removed
from the socket, before any left piece
can be removed.
• Check that the blade is suitable for the
spindle speed of the circular saw. Do
not attempt to cut before the circular
saw has reached full speed. Make sure
the circular saw runs without load (i.e.
is not in contact with the work) when
you switch it on. The circular saw must
have reached its full speed first.
• Never cut wood that is thicker than the
depth of the saw blade.
• When cutting in wooden walls or floors,
check there is no wiring or piping where
you intend to cut.
• Switch off the tool and wait until the
blade has stopped completely before
moving the saw away from the work or
putting it down. Hearing protection
should be worn when using circular
saw.
Switch off the machine immediately when
you discover:
• A defective mains plug or mains lead;
• A defective switch.
• Overheating of the circular saw.
• Smoke or odour caused by scorched
insulation.
6. Laser
Safety instructions for the laser cut-
6.1
ting guide
a. Do not point the laser beam at persons
or animals and do not look into the
laser beam. This laser emits a laser
beam that falls under laser class 2 in
accordance with EN 60825-1:2014. You
could blind people with it.
b. A laser is not a toy and does not
belong in the hands of children. Using
it incorrectly may result in irreparable
damage to the eyes.
c. It is forbidden to manipulate the laser
so as to increase its power in any way.
No liability will be assumed for any
damages caused as the result of fail-
ure to comply with these safety
instructions.
d. The laser does not contain any ser-
viceable parts. Therefore, do not open
the housing. Otherwise, you will ren-
der the warranty void.
e. Warning! Do not swap the laser with
another type of laser. Only the manu-
facturer of the laser or an authorised
representative may perform repairs.
f.
Do not point the laser beam towards
highly reflective surfaces.
g. Do not insert any hard objects in the
laser optics.
h. Clean the laser optics with a soft, dry
cloth.
7. Electrical safety
Always check that the voltage of
the power supply corresponds to
the voltage on the rating plate.
• Do not use the machine if the mains
cable or the mains plug is damaged.
• Only use extension cables that are suit-
able for the power rating of the machine
with a minimum thickness of 1.5 mm
If you use a extension cable reel, always
fully unroll the cable.
English
.
2
9
Publicité
