Fault Rectification; Environmentally Responsible Disposal - Maico EN 20 Instructions De Montage Et Mode D'emploi

12. Maintenance
The unit is maintenance-free.

13. Fault rectification

Fault Cause, measure
Fan does No mains voltage.
not switch on.
Check whether the mains
fuse has failed. Switch on
if necessary.
Impeller not Switch off unit. Ensure
turning. that the impeller is not
blocked by foreign bodies.
Motor's Motor too hot. Leave the
thermal unit switched off until the
overload motor and the
protection temperature limiter cool
switches the down. Cool-down time can
fan off. be up to 30 minutes. The
fan then starts up
automatically. Fault
rectification should only be
carried out by a trained
electrician.
Impeller is blocked.
Fan does
not switch on.
Fault rectification may
only be carried out by a
trained electrician:
Check impeller and clean
if necessary.
Observe information in the
The fan will
speed controller operating
stop and suffer
functional
instructions. Always set
problems if the
the minimum speed on the
output voltage
speed controller such that
on the speed
the fan motor starts up
controller is too
again after power failure.
low.
Deposits on Call on the services of a
the impeller trained electrician.
and in the
Under no circumstances
housing
should the inside of the
caused by dust
unit be cleaned with water
in the air.
or a high-pressure
cleaner.
If the fault still continues or occurs
again, disconnect the fan from the
power supply at all poles. Let a
certified electrician determine the
cause of the fault and eliminate it.
14. Spare parts
 Key Fig. 1:
Spare parts in bold.
When ordering spare parts, please provide
the following details:
1. Print no. of these instructions 0185.0992.0004.
2. Rating plate no. "X" at side on rating plate.
3. Item number according to Figure 1
Address for orders
Maico Elektroapparate-Fabrik GmbH
Steinbeisstraße 20
78056 Villingen-Schwenningen, Germany
Tel. +49 7720 694445 / Fax +49 7720 694175
E-mail: ersatzteilservice@maico.de
15. Dismantling
Dismantling should only be carried out by
a trained electrician.
1. Before dismantling, disconnect the unit at
all poles from the power supply (switch off
mains fuse), secure against being
accidentally switched back on and fit a
visible warning sign.
16. Environmentally responsible
disposal
The unit and the packaging contain parts that
can be recycled, and should not end up in the
domestic waste. Dispose of the packaging
material in an environmentally-friendly way,
in compliance with the regulations valid in the
country where you are.
At the end of its service life, dispose of the
unit in an environmentally-friendly way, in
compliance with the regulations valid in the
country where you are.
12. Maintenance │ UK
13