Atag VA6311RF Notice D'utilisation page 31

Setting and starting a washing programme
Starting the washing programme
without delay start
You can set the washing programme
with the appliance door open or
closed.
If the door is open, you can change the
setting, the appliance starts to operate
only after you close the door.
If the door is closed, the appliance
starts to operate after 3 seconds from
the setting of the washing programme.
1. Activate the appliance. Make sure that
the appliance is in setting mode.
2. Set the washing programme.
Do these steps to move the upper basket
to the higher position:
1. Pull the basket out until it stops.
2. Carefully lift the two sides until the
mechanism is engaged and the basket
is stable.
Do these steps to move the upper basket
to the lower position:
1. Pull the basket out until it stops.
2. Carefully lift up the two sides.
3. Hold the mechanism and let it fall back
down slowly.
Caution!
• Do not lift or lower the basket on one
side only.
• The related programme indicator
comes on. All the other programme
indicators go off.
• The programme time flashes in the
display.
• The phase indicators of the set wash-
ing programme come on.
3. Close the appliance door, the washing
programme starts automatically.
• The programme time flashes no more
in the display.
• Only the phase indicator of the phase
in operation stays on.
31