Atag VA6311RF Notice D'utilisation page 26

26
German degrees
(°dH)
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
You must adjust the water softener
manually and electronically.
Manual adjustment
Turn the water hardness dial to the position
1 or 2 (refer to the table).
Electronic adjustment
1. Activate the appliance. Make sure that
the appliance is in setting mode.
2. Press and hold function button (B) and
function button (C) at the same time un-
Use of dishwasher salt
How to fill the salt container:
1. Turn the cap counterclockwise and
open the salt container.
2. Fill the salt container with 1 litre of wa-
ter (only for the first time you fill with
salt).
3. Use the funnel to fill the salt container
with salt.
Water hardness
French degrees
(TH°)
91 - 125
76 - 90
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
< 7
mmol/l Clarke de-
grees
9,1 - 12,5 64 - 88
7,6 - 9,0 53 - 63
6,5 - 7,5 46 - 52
5,1 - 6,4 36 - 45
4,0 - 5,0 28 - 35
3,3 - 3,9 23 - 27
2,6 - 3,2 18 - 22
1,9 - 2,5 13 - 17
0,7 - 1,8 5 - 12
< 0,7 < 5
til the programme indicators above
function buttons (A), (B) and (C) flash.
3. Release function button (B) and function
button (C).
4. Press function button (A).
• The programme indicators above
function button (B) and function but-
ton (C) go off.
• The programme indicator above func-
tion button (A) continues to flash.
• The display shows the setting of the
water softener (example:
5).
5. Press function button (A) again and
again to change the setting.
6. Deactivate the appliance to confirm.
If the water softener is set electronically
to the level 1, the salt indicator stays
off.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the salt
container.
It is correct that water comes out from
the salt container when you fill it with
salt.
Water hardness ad-
justment
manually elec-
troni-
cally
1) 10
2
1) 9
2
1) 8
2
1) 7
2
1) 6
2
1) 1)
2 5
1 4
1 3
1 2
2) 2)
1 1
= level