Skil SD561801 Guide D'utilisation page 23

LED Worklight
Your tool is equipped with a LED
worklight, illuminating when the
trigger is squeezed. This provides
additional light on the surface of
the work piece for operation in
lower-light areas
(Fig. 5).
The LED worklight will
automatically turn on when
depressing the trigger switch, and turn off after the trigger switch is
released.
Install and Remove Bits
Your tool is equipped with a
magnetic bit holder, making bit
installing and removing very easy
(Fig. 6).
Lock the trigger switch "OFF" by
placing the direction-of-rotation
selector in the center position.
To install the bit:
Insert the bit into the holder. The
built-in magnet will help to securely hold the bit in place.
To remove the bit:
Just pull the bit out of the holder.
WARNING
cool down . The bit may be hot after prolonged use .
Use protective gloves when removing the
bit from the tool, or first allow the bit to
Fig. 5
LED Worklight
Fig. 6
23