EN
30
Stainless steel
The stainless steel must be cleaned regularly (weekly) to ensure a long service life.
For this, a special stainless steel cleaning fluid may be used.
Control panel
The control panel may be cleaned with warm soapy water. Make sure the cloth is
clean and well wrung out before cleaning the control panel. Use a dry, soft cloth to
remove excess moisture after cleaning.
Important: Use neutral detergents and avoid the use of harsh cleaning chemicals,
strong household cleaners, or products containing scouring agents as these may
affect the appearance of the device and possibly remove the printed symbols on
the control panel.
Grease filter
The fabric filters may be cleaned by hand. Soak them in
water together with a degreasing detergent for about 3
minutes, then gently brush them with a soft brush. Do
not apply too much pressure to avoid damaging the filter.
Then allow the filter to air dry, but do not place it directly
in the sun. Filters should always be washed separately
from dishes and kitchen utensils.
Remove the filter as shown in the picture at
right and then insert it again in reverse order.