Klarstein BARELLA Mode D'emploi page 25

Drill 3 holes (Ø 8 mm) in a suitable place on the wall
3
once the installation height is determined.
Place the dowels in the holes, screw the 2 screws ST4*30 mm
halfway into the dowels to fix the canopy body (see picture).
4
Mount the V-flap and the expansion tube on the cooker hood
and fix the expansion tube with a cable tie (see picture A).
Hang the cooker hood on the screws and fix the housing with 1
safety screw ST4*30 mm. Note: The two safety vents (diameter
of 6 mm) are located on the rear housing (see picture B).
5
A
Finally, guide the expansion tube to the outside.
6
B
EN
25