Haojue EG150 2019 Manuel D'utilisation page 36

(36) Haojue EG150 99011H11A81H000 V02 EN+FR 2019-4-24
help of the main stand.
2. Remove the engine oil dipstick (see the content above
"Oil level check").
3. Place a drain pan below the engine oil strainer cap 1.
Dismantle the engine oil strainer cap 1 to drain the
original engine oil.
NOTE: When dismantling the engine oil strainer cap, do
not lose the spring 3, the engine oil strainer 4 and the
seal ring 2.
4. Clean and inspect the engine oil strainer, if it is
EN
damaged, replace it.
5. Install the spring and the engine oil strainer.
6. Install the engine oil strainer cap 1.
NOTE: When installing the engine oil strainer cap, mount
spring 3 and strainer 4 and do not lose seal ring 2 on
the engine oil strainer cap.
7. Fill 900 milliliter of new engine oil into the engine via
the oil filling port of the dipstick.
8. Install engine oil the dipstick again.
9. Start the engine and have it run for several minutes.
10. Stop the engine and inspect the engine oil with
the dipstick several minutes later.
level should be between the UPPER LEVEL and the
LOWER LEVEL.
(36) Haojue EG150 99011H11A81H000 V02 EN+FR 2019-4-24
Use
"Instructions for use of fuel and engine oil".
Carefully inspect whether the engine parts that
have been dismantled and installed again suffer
any oil leakage.
It is suggested to replace the seal rings when the
engine oil filter element is replaced.
CLUTCH
Method to inspect the clutch cable gap 4: remove the
rubber bush 1 along the clutch cable, operate the clutch
The engine oil
handle and make sure there is a gap of 3–5mm before
there is an apparent resistance. If the gap is insufficient,
adjust it with the method below.
1. Remove the rubber bush 1 along the clutch cable,
loosen the nut 2.
34
BCAUTION
the engine oil recommended
BCAUTION
BCAUTION
in the