Haojue EG150 2019 Manuel D'utilisation page 12

(12) Haojue EG150 99011H11A81H000 V02 EN+FR 2019-4-24
LEFT TURN SIGNAL INDICATOR LIGHT
When the turn signal switch is pushed to left, the panel
left turn signal indicator light will flicker accordingly.
NOTE: If the turn signal fails to work due to a broken bulb
or faulty wire connection, the indicator on the dashboard
will remain light up continuously or flicker at a high
frequency.
TRIP METER RESET BUTTON
Turn the button counterclockwise to reset the trip meter 3
to zero.
EN
LEFT HANDLE SWITCHES
DIMMER SWITCH 1
"'" position
The headlight low beam and taillight will light up.
"9" position
The headlight high beam and taillight will light up. The
high beam indicator on the dashboard will also be lit.
(12) Haojue EG150 99011H11A81H000 V02 EN+FR 2019-4-24
=
Holding the dimmer switch between "9" and "'"
position will turn on both "9" and "'" headlight
beams. This operation can damage the motorcycle.
Use the dimmer switch only at "9" and "'"
position. Do not stick tape on the headlight or
place objects in front of the headlight.
OVERTAKING SWITCH 2 :
Press the switch to flash the headlight.
CLUTCH LEVER 3
The clutch lever is used for disengaging the drive to the
rear wheel when starting the engine or shifting gears.
Grasping the lever disengages the clutch.
HORN BUTTON 4 ,
Pressing this button will trigger the horn.
TURNING SIGNAL SWITCH 5 = 8
Moving the switch to the "=" position will engage the
left turn signals. Moving the switch to the "8" position
will engage the right turn signals. The indicator on the
dashboard will also flash. To cancel turn signal operation,
push the switch inward.
10
BCAUTION