Max PowerLite AKHL1320E Mode D'emploi page 8

Tab.1 SECTION VALID FOR A MAX LENGTH OF 20m
COMPRESSOR
AKHL1320E (CE)
WARNING
Avoid electrical shock hazard. Never use this
compressor with a damaged or frayed electrical
cord or extension cord. Inspect all electrical
cords regularly. Never use in near water or in any
environment where electric shock is possible.
15. STAY ALERT
Watch what you are doing. Use common
sense. Do not operate compressor when you
are tired. Compressor should never be used by
you if you are under the influence of alcohol,
drugs or medication that makes you drowsy.
16. CHECK DAMAGED PARTS AND AIR
LEAK
Before further use of the compressor, a guard
or other part which is damaged should be care-
fully checked to determine that it will operate
properly and perform its intended function.
Check for alignment of moving parts, binding
of moving parts, breakage of parts, mount-
ing, air leak, and any other conditions that
may affected its operation.
A guard or other part that is damaged should
be properly repaired or replaced by an au-
thorized service facility unless otherwise in-
dicated elsewhere in this Instruction Manual.
Have defective pressure controllers re-
placed by authorized service facility.
Do not use compressor if switch does not
turn it on and off.
17. OPERATE COMPRESSOR CORRECTLY
Operate the compressor according to the in-
structions provided herein. Never allow the
compressor to be operated by children, indi-
viduals unfamiliar with its operation or unau-
thorized personal.
18. KEEP ALL SCREWS, BOLTS AND COV-
ERS TIGHTLY IN PLACE
Keep all screws, bolts, and plates tightly
mounted.
Check their conditions periodically.
HP kW
2 1.5
19. KEEP HANDLES DRY, CLEAN AND FREE
20. KEEP MOTOR AIR VENT CLEAN
21. OPERATE COMPRESSOR AT THE RAT-
22. NEVER USE A COMPRESSOR WHICH IS
23. DO NOT WIPE PLASTIC PARTS WITH
24. USE ONLY GENUINE REPLACEMENT
8
VOLTAGE
a.c. 230V
FROM OIL AND GREASE
Slippery handles do not allow for safe handling
of the compressor in unexpected situations.
The motor air vent must be kept clean so that
air can freely flow at all times. Check for dust
build-up frequently.
ED VOLTAGE
Operate the compressor at voltages speci-
fied on their nameplates. If using the com-
pressor at a higher voltage than the rated
voltage, it will result in abnormally fast motor
revolution and may damage the unit and
burn out the motor.
DEFECTIVE OR OPERATING ABNOR-
MALLY
If the compressor appears to be operating
unusually, "SERVICE REQURED" LED is lit
up, making strange noises, or otherwise ap-
pears defective, stop using it immediately
and arrange for repairs by an authorized
service facility.
SOLVENT
Solvent such as gasoline, thinner, benzine,
carbon tetrachloride, and alcohol may dam-
age and crack plastic parts. Do not wipe
them with such solvents. Wipe plastic parts
with a soft cloth lightly dampened with mild
detergent and dry thoroughly.
PARTS
Replacement parts not original may void
your warranty and can lead to malfunction
and resulting injuries. Genuine parts are
available from your dealer.
MINIMUM GAUGE
2
2.5mm