Max PowerLite AKHL1320E Mode D'emploi page 16

4. MACHINE OPERATING PROCE-
DURE
Inspection and checkup prior to oper-
ation
WARNING
• Prior to use, check the bolts and nuts for
loosening and the parts for missing one.
• Use the outlet of the building installation
with a proper protection for the power sup-
ply of this compressor. Failure to use a
proper protection for the power supply, it
may cause electric shock and damage to
the compressor. Allowable source voltage
range is ±10%.
CE: a.c.230V/10A
• Diameter and length of the extension cord
or drum cord used must be the following,
respectively. And the cord must be fully
drawn out when used.
CE: Diameter 2.5mm
20m maximum
• Make sure the machine is installed in the
right direction when using it.
∗ Use the machine in compliance with the in-
structions provided in "SAFETY INSTRUC-
TIONS" on page 6.
∗ Pressure values in the description do not in-
clude the error in reading the pressure gauge.
1. After turning off the machine power
switch, connect the power plug to the
outlet.
2. (Fig.C,D) Turn the power switch on while
maintaining the drain cock fully open.
The buzzer sounds with a beep at the
same time.
• For buzzer sounding patterns, see
page 19.
3. (Fig.D) Make sure that the motor starts to
run and the air is leaking from the drain
cock when the drain cock is open.
4. (Fig.E) Close the drain cock and make
sure no air is leaking from the cock.
minimum / Length
2
5. Turn the adjustment handle (in 2 loca-
tions) of the pressure-reduction valve ful-
ly clockwise until you cannot move it
anymore and make sure that the above
operation moves the pressure gauge
pointer (Fig.F) at both locations.
CAUTION
• As the pressure in the air tank increases
due to the pressure characteristic of the
pressure-reduction valve, the pressure can
vary from the set supply pressure by as
much as 3 bar.
Turn the pressure-reduction valve's adjust-
ment handle counterclockwise once to re-
duce the pressure and then proceed to the
adjustment while increasing the pressure
by turning the adjusting hand clockwise.
6. Make sure that the compression opera-
tion is automatically stopped in the fol-
lowing time.
• 1320E approx. 6 minutes
• 1320E+AKTH15 approx. 12 minutes.
Except when the power-saving operation
in Quiet mode is turned on, auxiliary tank
is connected or voltage drop occurred,
since these extends the operating hours.
7. Wait for 5 minutes after the operation is
stopped to confirm that there are no ab-
normal noises or air leakages and that
the compressor does not restart.
8. (Fig.D) Discharge the compressed air by
opening the drain cock somewhat. Make
sure that the operation is resumed due to
a decrease in the pressure.
9. (Fig.E,G) Close the drain cock and turn
the power off while the compression op-
eration is turned on to make sure that
these actions stop the machine from op-
erating.
10. (Fig.H) Turn the adjustment handle (in 2
locations) of the pressure-reduction
valve counterclockwise to make sure that
this turning moves the pressure gauge
pointer downward at both locations. (You
may hear sounds due to air leaking but it
does not mean there is a failure.)
16