Publicité
Les langues disponibles
Les langues disponibles
Receiver diagram
The cables from the servo connector board should be con-
nected to your receiver in the order shown. Note that the
LEDs can be powered by any spare channel on the receiv-
er. Tuck the wire leads into the recessed cavity towards
the rear of the battery hatch.
Get your model ready to fly
Transmitter and model setup
Before getting started, bind your receiver with your transmitter.
Please refer to your transmitter manual for proper operation.
CAUTION: To prevent personal injury, DO NOT install the propel -
ler assembly onto the motor shaft while testing the control surfac -
es. DO NOT arm the ESC and do not turn on the transmitter until
the Transmitter Manual instructs you to do so.
Tips: Make sure all control sticks on your radio are in the neutral
position (rudder, elevator, ailerons) and the throttle is in the OFF
position. Make sure both ailerons move up and down (travel) the
same amount. This model tracks well when the left and right
ailerons travel the same amount in response to the control stick.
Move the controls on the transmitter to make sure the aircraft
control surface moves correctly. See diagrams right.
Gear
EIevator
Throttle
Rudder
Gear
Spare
Bank left
Bank right
Climb
Descend
Steer left
Steer right
7
1
2
3
4
5
Gear
6
Spare
E
N
5
6
Publicité
