Télécharger Imprimer la page

FMS 80mm INTEGRAL Manuel D'utilisation page 15

Publicité

Les langues disponibles

Les langues disponibles

Program the ESC with your transmitter (4 Steps)
Note: Please make sure the throttle curve is set to 0 when the throttle stick is at bottom position and 100%
for the top position.
NO.1 Enter program mode
1.Switch on transmitter, move throttle stick to top position, connect the battery pack to ESC
2.Wait for 2 seconds, the motor should emit special tone like "beep-beep-"
3.Wait for another 5 seconds, special tone like "♪56712" should be emitted, which means program mode is
entered.
NO.2 Select programmable items
After entering program mode, you will hear 8 tones in a loop with the following sequence. If you move the throttle
stick to bottom within 3 seconds after one kind of tones, this item will be selected.
Prompt tone
"beep"(1 short tone)
"beep-beep-"(2 short tone)
"beep-beep-beep-"(3 short tone)
"beep-beep-beep-beep-"(4 short tone)
"beep——"(1 long tone)
"beep——beep-"(1 long 1 short)
"beep——beep-beep-"(1 long 2 short)
"beep——beep——"(2 long tone))
Note: 1 long "beep-----" = 5 short "beep-"
NO.3 Set item value (Programmable value)
You will hear several tones in loop. Set the value matching to a tone by moving throttle stick to top when you hear
the tone, then a special tone "♪1515" emits, means the value is set and saved. (Keeping the throttle stick at top,
you will go back to Step 2 and you can select other items; or moving the stick to bottom within 2 seconds will exit
program mode directly) .
Tones
Items
Brake
Battery type
Cutoff mode
Cutoff threshold
Start mode
Timing
NO.4 Exit program mode
There are 2 ways to exit program mode:
1. In step 3, after special tone " ", please move throttle stick to the bottom position within 2 seconds.
2. In step 2, after tone "beep-----beep-----"(that is: The item #8),move throttle stick to bottom within 3 seconds.
"beep-"
1 short tone
Off
Lipo
Soft-Cut
Low
Normal
Low
15
Selected item
brake
battery type
cutoff mode
cutoff threshold
startup mode
timing
set all to default
exit
"beep-beep-"
2 short tones
On
NiMH
Cut-Off
Medium
Soft
Medium
"beep-beep-beep"
3 short tones
High
Super soft
High

Publicité

loading

Ce manuel est également adapté pour:

Man-g0244