Publicité
Les langues disponibles
Les langues disponibles
Care & Maintenance
Fig. 21
CLEANING AFTER A BREW
CAUTION: Make sure that the brewer is unplugged
from the power source before cleaning.
CAUTION: Be sure to allow the brewer to cool before
cleaning.
NOTE: Do not leave coffee in the thermal carafe for an
extended period of time after a brew.
NOTE: Do not leave water in the reservoir unused for
multiple days. Rinse and replace with fresh water.
1
Before cleaning, close the Drip Stop.
2
After each brew is complete and the coffee grounds have
cooled, carefully remove the permanent filter and wash. If
using a paper filter, simply discard. Remove brew basket from
the brewer, rinse and wash with soap and warm water.
NOTE: The brew basket and thermal carafe are not
dishwasher safe.
NOTE: If coffee grounds spilled over into the brew basket or
in the overflow channels, remove and rinse under water until
grounds are removed.
3
Wash the thermal carafe and brew-through lid with soap and
warm water. Use a bottle brush or a cloth to wash the inside
of the carafe.
4
Wipe machine down with a warm cloth with soap and water
to clean the base plate and outer parts. Do not immerse
the base in water.
NOTE: For best results, use a bottle brush. This will allow you
to scrub all of the inside with soap and hot water.
CLEANING YOUR THERMAL CARAFE
We recommend rinsing your carafe with warm
soapy water.
CAUTION: DO NOT place the
thermal carafe in the
If you want to clean the carafe more thoroughly,
we recommend using a soft foam brush such as
the one shown.
21
1-877-646-5288
H
M
dishwasher.
CLEANING YOUR WATER RESERVOIR
1
Empty the water reservoir.
2
Hand wash with dish soap and rinse or place on the top rack
of your dishwasher.
CLEANING & DESCALING YOUR BREWING SYSTEM
CAUTION:
Be sure to allow the brewer to cool before
wiping down any surface for
CAUTION: DO NOT immerse the coffeemaker into water
or any other liquid.
NOTE:
To cancel the clean cycle, press any brew type button.
Turning the brew size dial will cause the unit to beep for 6
seconds before canceling the clean cycle.
NOTE:
Pressing the CLEAN button again during the clean
cycle will cause the machine to brew through all remaining
cleaning solution; however, your machine will not be properly
descaled.
The CLEAN button will illuminate when a cleaning cycle is
recommended for your Ninja Coffee Bar
buildup could be affecting the flavor of your coffee. If you do
not clean your brewer when instructed to do so, eventually
the CLEAN light will flash and an urgent "Cln" message will
appear on the clock display. The cleaning cycle is a 2-stage
process. The reservoir is first filled with a cleaning solution
and later with clean water to flush the system.
To clean and descale your Ninja Coffee Bar:
1
Select the Full Carafe size and set the empty carafe beneath
the brew
basket.
2
(Recommended)
Use a descaling solution specifically
formulated for coffeemaker cleaning and follow the directions
on the package. Fill the water reservoir up to, but not
exceeding, the Max Fill line (43 oz.).
Fill the water reservoir to the Travel Mug line (16 oz.) with
white vinegar, then fill the rest of the reservoir with water up
to, but not exceeding, the Max Fill line (43 oz.).
IMPORTANT: Use only white vinegar.
3
Once the water reservoir is filled with your cleaning solution
and water mixture, press the Clean
NOTE: The clean cycle takes approximately 60 minutes.
4
Your Ninja Coffee Bar will deliver a small amount of cleaning
solution to distribute it through the system. It will then pause
for a half an hour as a 30-minute timer on the clock display
counts down. The Ninja Coffee Bar will then deliver additional
cleaning solution, and pause while another 30-minute timer
counts
down.
CAUTION:
DO NOT remove carafe at any time
throughout the clean cycle. DO NOT press any buttons
during this 1-hour period, as this will cancel all
progress of the
cleaning.
cleaning.
, as calcium scale
®
OR
button. (Fig. 21)
Publicité
