Ninja Coffee Bar CF087 Manuel Du Propriétaire page 16

Setting the Clock & Delay Brew
OFF
Fig. 1
TO SET THE CLOCK
1
Plug the power cord into an electrical outlet. The clock
will flash on the control panel to indicate that the time
has not been set. (Fig. 1)
2 Press the H (hour) or M (minute) button until you reach
the current time. The AM or PM indicator will illuminate
on the
left side of the display as you are setting the time.
3 After 5 seconds the clock will stop flashing and the
clock will be set.
NOTE: If the clock stops flashing and does not display
the correct time of day, pressing the H (hour) or the
M (minute) button at any time will again will cause
the clock to flash again. You can now re-program the
correct time of day by following the steps above.
NOTE: If you unplug the brewer or in the event of an
extended power loss, you will need to reset the clock
the next time the brewer is plugged in.
TO SET THE DELAY BREW TIME
NOTE: The Ninja Coffee Bar
the delay brew function to work. Do not power off after
setting Delay Brew.
1
Press Delay Brew. The Delay Brew button will illuminate
and the clock will begin to flash "12:00" or the last
delay brew time that was set. (Fig. 2)
2
While the clock is flashing, press the H (hour) or M
(minute) button to set the time that you would like
the delay brew to begin. The AM or PM indicator will
illuminate on the left side of the display as you are
setting the desired time.
15
1-877-646-5288
Fig. 2
must remain on in order for
®
OFF
3
Once the proper time has been set, select the size of
the vessel that you would like to brew.
4
Select the Brew Type that you desire from the 4 flashing
buttons. The selected brew type will be lit. (Fig. 3)
5
Once the time, brew size, and brew type have been set,
allow the Delay Brew to flash and lock in or press the
Delay Brew button to activate the Delay Brew. When
the Delay Brew is activated, the light on the Delay Brew
button will illuminate and an audible signal will play to
verify the Delay Brew is set.
6
The Delay Brew time is now set and your Ninja
Coffee Bar will automatically brew at the time you
®
programmed.
NOTE: To deactivate the Delay Brew cycle, press the
Delay Brew button once more and the light on the Delay
Brew button will turn off. Any change to the selected
brew size or starting any other brew will cancel the
programmed Delay Brew.
7
Place the appropriate-sized
vessel under brew basket for
the selected size.
IMPORTANT: Make sure
the Drip Stop is in the open
position.
Go to ninjakitchen.com for more
information and how-to videos.
OFF
Fig. 3