Publicité
Les langues disponibles
Les langues disponibles
Checking
the tension:
Use
a screwdriver
to move
chah_ around
guide bar. If the chain does not rotate, it is too
tight. Ifthe chain is too loose, it will sag below
the bar.
Guide
Bar
3.
Using a screwdriver,
move chain around
guide bar to ensure
all links are in bar
groove.
4.
While lifting tip of guide bar, tighten bar
knob securely
(clockwise).
Hand tight-
en only?
Adjusting
Bar
Screwdriver
Wheel
Knob
Adjusting
the tension:
Chain tension is very important. Chains stretch
during use. This is especially true during the
first few times you use your saw. Always check
chain tension each time you use and refuel
your saw.
1.
Lift lever on bar knob and turn counter-
clockwise
1 turn to loosen
bar clamp.
_OOSEN
Turn adjusting
wheel
(downward
direc-
tion) to tension chain until chain solidly
contacts
bottom of guide bar rail. Lift tip
of guide bar while adjusting
tension.
Tighten
Loosen
chain
chain
Adjusting
Wheel
TIGHTEN
5.
Push lever on bar knob down to return
lever to closed/locked
position.
_lk WARNING:
Failuretopushleveron
bar
knob
down
to closed/locked
position
could
result
in serious
personal
injury
or
damage
to your chain saw.
6.
Use ascrewdriver
to move chain around
guide bar.
7.
If chain
does not rotate, it is too tight.
Loosen
bar knob 1 turn (counterclock-
wise);
then, loosen chain by turning the
adjusting
wheel
1/4 turn (upward
direc-
tion). Retighten
bar knob.
8.
If chain is too loose, it will sag below the
guide
bar. DO NOT operate the saw if
the chain is loose.
WARNING:
If the saw is operated
with a loose chain, the chain could jump off
the guide bar and result in serious
injury.
_b, WARNING:
Muffler is very hot dur-
ing and after use. Do not touch the muffler or
allow
combustible
material
such
as
dry
grass or fuel to do so.
Publicité
