Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
The appliance requires being vented outside so that the exhaust air can escape the room which coming from
the appliance contains waste heat and moisture.
Do not replace or extend the exhaust hose which will result in decreased efficiency, even worse shut down
the unit due to low back pressure.
The unit shall be installed on a flat surface where the air outlet would not be blocked. To ensure the
proper air circulation, the required free space around the unit should be at least 50 cm.
The unit shall not be installed in a laundry room.
Connect the hose connector to one end of the exhaust hose. Connect the window kit adapter to the other end of
the exhaust hose.
To assemble the window kit: make the board B slide beneath the board A; make the provided screw go through the
small hole on board A while the flat side of the screw is embedded into the center groove of board B. Adjust the
boards to the desired length fitting your window; screw on the washer and then the butterfly nut above to fix the
connection of boards.
Connect the exhaust hose onto the window kit by inserting the window kit adaptor into its place on board A.
- 8 -
Publicité
