Publicité
Les langues disponibles
Les langues disponibles
1) Cooling mode
When the room temperature is higher than the set temperature, the compressor starts to run.
When the room temperature is lower than the set temperature, the compressor stops and the fan
operates at the set speed.
Note: When the compressor is working, the unit will vibrate slightly. This is normal and harmless.
2) Drying mode
The fan runs at low speed. The fan speed and temperature cannot be adjusted.
The compressor will work according to the room temperature as following:
＞25℃
20℃ ≤ room temperature ≤ 25℃
15℃＜room temperature＜20℃
room temperature ≤ 15℃
3) Fan mode
The adjustment of temperature in fan mode is not effective.
In fan mode, the room air is circulated but not cooled.
4) Heating mode
When the room temperature is higher than the set temperature, the unit will stop the heating function.
When the room temperature is lower than the set temperature, the unit will start the heating function.
3. Sleep button (only active in cooling mode and heating mode)
Press the sleep button to activate the sleep mode. The sleep indicator light turns on.
In sleep mode, the appliance automatically runs in low fan speed which cannot be changed.
-
Under cooling mode: The set temperature increases by 1℃ per hour for the first two hours and
then keep unchanged.
-
Under heating mode: the set temperature decreases by 1℃ per hour for the first two hours and
then keep unchanged.
After working 12 hours under sleep mode, the appliance will turn off automatically.
4. Temperature/timer increasing button & temperature/timer decreasing button
The temperature adjustment is only effective in the cooling mode and heating mode.
Press the button "
also be used for timer adjustment during timer setting. The value will be increased/decreased by 1 (℃
/hour) for each press.
Note: In cooling or heating mode, the set temperature will be shown on the digital display; in fan or
drying mode, the room temperature will be shown on the digital display.
5. Swing button
Press the swing button to activate the swing function, and the cover above the air outlet will swing slowly.
To stop the swing, just press the button again.
The compressor will stop after 15 minutes of running and then
run again after 3 minutes.
The compressor will stop after 10 minutes of running and then
run again after 3 minutes.
The compressor will stop after 6 minutes of running and then run
again after 3 minutes.
The compressor will stop running and run again once the room
temperature ≥ 17℃.
"/"
" to set your desired room temperature from 16℃ to 32℃. The buttons can
- 10 -
Publicité
