Mediclinics M99AB Manuel D'installation Et D'utilisation page 7

Automatic models:
These models operate by hand detection. If hands are held 10-15 cm (3,9-5,9") from the air
outlet, the dryer will start working. Immediately after the hands can be gradually taken away
from the dryer and will continue drying up to a maximum distance of 15-20 cm (5,9-7,9"). The
machine stops will stop 2-3 seconds after use. If the sensor isblocked due to vandalism, the
dryer will completely stop working.
Please let a minimum separation of 40 cm (15,75") between appliance and any shelf,
marble, worktop or washbasin.
PREVENTIVE MAINTENANCE AND CLEANING
Correct cleaning of the machine will lenghten its working life considerably. When in use, the
machine will accumulate dust inside which should be cleaned out if used regularly, at least once
a year.
• Disconnect the dryer lead-in wire.
• Unscrew the 4 side attachment screws using the supplied Allen key.
• Remove cover (See dismantling for installation).
• Remove the accumulated dust in the fan wheel with a soft bristle brush.
• Using the same brush, remove the dust accumulated in the out grill.
• Brush the sides between the support and the wall.
• We recommend removing the machine from the wall and unscrewing the four mounting bolts
to remove any obstructions (paper, cigarette ends, etc.).
• In case of having dismantled the air outlet, install it again in its place and ensure that it is in its
proper position.
• When maintenance is complete, screw the base to the wall (if applicable), re-mount the cover,
tighten up the screws and plug in.
• Switch on the machine and leave running until all traces of dust from the cleaning proces have
been discharged from the air stream.
• Clean the casing using a damp cloth moistened in a solution of neutral soap and water.
After cleaning the entire surface rinse the soap from the casing using another cloth moistened in
water and dry using a dry cloth.
CLEANING OF CHROMED COVERS
For cleaning purposes only a wet cloth is to be used. Do not use any kind of detergent,
acids, lye, abrasives, hydrochloric acid, etc. Take care not to damage or force any
component.
-7-