Mediclinics M99AB Manuel D'installation Et D'utilisation page 6

Mounting
• Mount the machine along the rear channels.
• Insert the electric ducting through the hole next to the terminal strip.
• Use the drill template provided to fix the dryer to the wall.
• Drill 4 holes with a diameter of 8 mm(5/16"),
and take care to clean all traces of dust from the holes.
• Screw down the base firmly to the wall using a flat
ended screwdriver of 6 -7mm (1/4").
• Connect the electric ducting to the terminal strip.
Screw down the 3 locking screws firmly.
• To fix the machine with adhesives or similar methods is forbidden by the European safety
standards.
Means for disconnection of the mains should be predicted, with a contact separation at
least 3 mm (0.12") in all poles. The mentioned means of disconnection must be
incorporated in the fixing wiring.
ADJUST DETECTING DISTANCE
The hand dryer has means to adjust manually
the distance for detecting hands.
These adjustments of the motor
speed must be made by a qualified technician only.
The adjustments can be made by
moving the cursor of the linear potentiometer.
METHOD OF USE
To dry hands correctly, we recommend rising well to remove all traces of soap.
Button models:
Press the start button. Immediately after approach the hands to the air outlet and rub
them together. The hands can be gradually taken away from the dryer and will continue
drying up to a maximum distance of 10-15 cm (3,9-5,9").The handryer worksduring 40
seconds. After that it stops and will be ready to work again.