Télécharger Imprimer la page

Zanussi ZRB34103XA Notice D'utilisation page 25

Publicité

Les langues disponibles

Les langues disponibles

If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Replacing the lamp
The appliance is equipped with a
longlife LED interior light.
CAUTION!
Disconnect the plug from the mains
socket.
Installation
WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Service Centre
www.zanussi.com
1. At the same time, with the fingers expand
up and down the transparent cover and
unhook it in the direction of the arrows.
1
2
1
2. Replace the lamp with one of the same
power and shape, specifically designed for
household appliances. (the maximum power
is shown on the light bulb cover).
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light comes on.
Electrical connection
• Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
• The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a
qualified electrician.
• The manufacturer declines all responsibility if
the above safety precautions are not
observed.
• This appliance complies with the E.E.C.
Directives.
25

Publicité

loading