Télécharger Imprimer la page

Zanussi ZRB936PW2 Notice D'utilisation page 24

Publicité

Les langues disponibles

Les langues disponibles

Problem
Water flows into the refrig-
erator.
Water flows on the ground. The melting water outlet does not
There is too much frost
and ice.
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.
The temperature in the re-
frigeration is too high.
The temperature in the
freezer is too high.
The appliance does not
operate.
The lamp does not work.
If your appliance is still not working properly af-
ter making the above checks, contact the After
Sales Centre.
Replacing the lamp
1. Disconnect the appliance.
2. Push the movable part to unhook the lamp
cover (1).
24
Possible cause
The water outlet is clogged.
Products prevent that water flows
into the water collector.
flow in the evaporative tray above
the compressor.
Products are not wrapped properly.
The door is not closed correctly.
The Temperature regulator may be
set incorrectly.
The Temperature regulator may be
set incorrectly.
The Temperature regulator may be
set incorrectly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each oth-
er.
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet to the
evaporative tray.
Wrap the products better.
Refer to "Closing the door".
Set a higher temperature.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same
time.
Make sure that there is cold air circu-
lation in the appliance.
Store products so that there is cold
air circulation.
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket. Contact a
qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
3. Remove the lamp cover (2).
4. If needed replace the lamp with a light of
similar characteristic and power. It is sug-
gested to use Osram PARATHOM SPE-
CIAL T26 0.8 Watts.
5. Install the lamp cover.
6. Connect the appliance.
Solution
www.zanussi.com

Publicité

loading

Ce manuel est également adapté pour:

Zrb936px2